€3,885 + VAT @ 23%

Alfra GmbH Press 250 Complete with pivoting framework



orCall +353 838108745


Alfra Press 250: Complete with pivoting framework and AHP S Drive Unit

For rapid punching-out of circular, square, rectangular or special forms

without pre-drilling in control cabinet doors, terminal boxes, cable ducts,

housings, cable management panels etc. right up to margins. Simple tool

change carried out in seconds.


Flexible in use – on mobile base (optional) or stationary, fi tted on the


Rapid tool change helps in problem areas with a wide range of break-

through types

A range of die mountings is available, even for punching very close to


Rows of punch-outs are no problem thanks to attachable folding stops

Tip: Use a laser pointer as an option - no scribing, no centre punching,

a simple crosshair with the pin is suffi cient

Operation using a manual pump is suffi cient as a “starter solution” – this makes “punching without pre-drilling” possible at low cost

Technical Specifications:

Overhang with limit stop: 250 mm

Overhang without limit stop: 265 mm

Punching stroke: 50 mm

Punching force F: 46 kN at 600 bar

Hydraulic connection: R 1/4"

Weight without base: 50 kg

Weight with base: 120 kg

Space requirement with base approx.: 1,000 mm x 1,000 mm

Punching capacity:

Circular: Ø 3.2 - 40.5 mm

Square: 28.0 x 28.0 mm

Rectangle: 22.0 x 30.0 mm

Special forms up to a max. diagonal of: 40.0 mm

Material thicknesses (max):

Sheet steel (S235): 2.5 mm

Stainless steel (F = 600 N/mm2): 2.0 mm

Aluminium (F = 22 N/mm2): 4.0 mm

Punchable plastics: 4.0 mm


ManufacturerAlfra GmbH
ModelPress 250 Complete with pivoting framework
Overhang with limit stop250 mm
Overhang without limit stop265 mm
Punching stroke50 mm
Hydraulic connectionR 1/4"
Weight without base50 kg
Weight with base120 kg
Square28.0 x 28.0 mm
Rectangle22.0 x 30.0 mm
Sheet steel (S235)2.5 mm
Punchable plastics4.0 mm